Painting and Staining

FilmCrewHomes.com – Painting and Staining

FilmCrewHomes.com-paint-wall FilmCrewHomes.com-painting-wall

If you keep the paint on your home in good condition, the seams and joints well caulked and the walls tidy, you will significantly decrease the potential of wood decay and moisture entering into your house. Paint will blister and peel with time due to exposure to sun light and damaging weather conditions. When this takes place, you are allowing water to get into your house.

FilmCrewHomes.com-Pealing-paint

The right way to repaint an area that is blistering and peeling is to remove all of the loose paint. Wash the area with a mild detergent, then rinse off the surface and let it dry thoroughly. When the surface area is completely dried, caulk the areas where that is called for, reset loose nails, putty over holes and flaws, and paint a primer coat on all bare surfaces. Once more let the location to dry. Lastly, use 2 coats of paint making sure that each coat of paint dries completely. By preparing the surface area properly, you will extend the time between paintings.
If you have metal siding, you will need to follow the very same method but you will use a wire brush to remove the surface area of any rust and dirt. Make certain to apply a metal primer prior to using the two coats of paint. Painting or staining, coupled with caulking, will keep the wood around the outside of your home from rotting. Your local hardware shop can advise you about the kinds of paints you have to use for the kind of surface you are painting.

Brick and Mortar Repairs

FilmCrewHomes.com-patch-brick

It is not uncommon for the mortar between bricks to crack. Again, fractures will allow dampness and water to permeate into your house. Fixing mortar is a basic procedure that many people can do. Just like every other repair process, be sure to clean up the surface area effectively. You can eliminate the itty-bitty particles by flushing with a hose or by employing a wire brush. Mortar can be acquired at any hardware depot. You will want to match the color of your mortar, so you may need to take a sample with you when you go to the store. Then blend the mortar and wet the surface that you will be filling. Next push the mortar into the seams with a jointer tool. After a couple of minutes, remove the excess mortar and enable the joints to dry.

Painting and Staining – A word of caution:

At the bottom of each wall you will discover little openings called weep holes. They are there to permit wetness to exit. Locate the weep holes, then be sure to leave them open so they can let trapped wetness exit.
Just like any preventive upkeep, prior to making repairs to your outside walls, discover the source of the problem. Covering up a concern will not make the issue go away. The longer an issue exists, the more it is most likely to cost you more to fix. Be sure to go right to the source of the concern prior to making any fixes.